APOD FIrearms

Recent content by scooterj

The Best online firearms community in Louisiana.

Member Benefits:

  • Fewer Ads!
  • Discuss all aspects of firearm ownership
  • Discuss anti-gun legislation
  • Buy, sell, and trade in the classified section
  • Chat with Local gun shops, ranges, trainers & other businesses
  • Discover free outdoor shooting areas
  • View up to date on firearm-related events
  • Share photos & video with other members
  • ...and so much more!

    • Register Log in
    1. S

      Glock Trigger Reset Issue

      Looks to me that replacing the connector with a new OEM unit should cure your problems
    2. S

      Glock Trigger Reset Issue

      The connector should not be flat against the housing. Lots of folks bend them straight because it doesn’t look right.
    3. S

      Recommendations for a inexpensive 9mm single stack 1911?

      Just a little something to think about: Tisas/Girsan are made in Turkey and are forged frames and slides. Rock Island and variants are cast and made in the Philippines. The forged parts will hold tighter tolerances for a longer time.
    4. S

      Recommendations for a inexpensive 9mm single stack 1911?

      Recently picked up this Girsan 9mm. I am more than pleased with reliability and accuracy. The price is a little more than you stated though.
    5. S

      handgun pictures thread

    6. S

      handgun pictures thread

    7. S

      Fire Star M45

      Not rare from a collector’s standpoint but they don’t show up often.
    8. S

      7 prc recommendations

      Lone Wolf Rifles in Georgia. Tell Bobby that Scooter sent you. lonewolfrifles.com
    9. S

      AXIL hearing protection

      https://isotunes.com/products/caliber-bt
    10. S

      AXIL hearing protection

      I have been using the ISO Tunes Caliber BT buds for a year or so. I just ordered another set to use at work. 12-13 hours per charge. The case holds another two charges in its battery. They come with different size and material inserts. Same price range as the Axils.
    11. S

      EAPS - February Hit Factor Match. 2-18-24

      In!
    12. S

      New member to the 1911 gang now!

      If Mr D is who I think it is, you had a good teacher!
    13. S

      Opinions RE: RMSc footprint optics

      C-more CRC is my choice for that footprint. It’s a solid sight and the dot is round and well defined.
    14. S

      What parts do I need to get a 3lb trigger on my R/I 1911?

      Bend the left leg back about 1/16”. Make the bend as low as possible. Lay the spring on it’s side and trace the shape on a piece of paper. Use that as your guide. Measure the change at the very top. Too much bend and the hammer will start to follow the slide.
    15. S

      Gunsmith needed.

      Try tightening the ejection rod. It’s a left hand thread. If it backs out, the locator pin on the rear of the cylinder won’t get pulled far enough out.
    See more
    Top Bottom