I also use this same suppressor on a HK USP 9 and a Beretta M9 with the same set-up (just switching the spring for the spacer). They are both pretty consistent with POI when switching between suppressed and unsuppressed.
If it was blow-by causing the issue, wouldn't it present itself with the...
I would like to be able to shoot it suppressed and unsuppressed. As it is now, I have flip up sights for when unsuppressed and an optic when suppressed.
I have modified a 5" flash hider to fit when shooting unsuppressed to protect the inside of my hand guard as well as my hand. I have tried...
I have put together a 9mm SBR upper for suppressor use (being used on a registered SBR lower). Barrel was supplied by ADCO and is 4.5" and threaded 13.5 x 1 LH with a 1 in 10 inch twist rate. It is being used with an AAC TI-rant.
I know that most firearms will exhibit some impact shift with...
I understand the point of sending it to someone that is known and has a good reputation. However, how can someone get positive or negative feedback if no one ever gives them a chance.
czar has used the guy and says it turned out good. Hopefully Hoghunter will have good results too.
Like has...
I ran across "EliteTacticalWeapons.Com" while searching for some other stuff one day. They show to be in Shreveport and they have a few pics of engraving shown on their website. I spoke to someone there and I think he quoted $40-$45 for engraving for an SBR (don't quote me on that though)...
I purchased one and had the same problem. I purchased some 2 X 6 boards and bolted the thrower to them. It increased the footprint of the thrower and added some weight which helped keep it from jumping around so much. The only problem I have now is it will break the last one when it tries to...
I agree with everyone else. It is not hard to do yourself. I am not a gunsmith but I would not mind helping. I am east of Shreveport about 45-60 minutes.
You can try the JP 3.5 lb hammer spring but that could possibly cause light primer strikes on some of the more stubborn .223 primers (I have not had this problem on my ARs but I am only 1 person).
You can also try a Lakeside spring for the .22 conversion kit. They are usually longer than the...
I have fired the CCI Subsonic rated at 1050 fps as well as the CCI standard velocity rated at 1070 fps out of my 10/22, spikes upper, and savage bolt action (all with the Sparrow attached) without any issues. I agree, definitely a lot of fun.
My dad had a rifle re-blued by Athens Gunsmith Service about 3-4 months ago. Not sure if he would be able to match the existing bluing on your pistol, but there is no doubt he could re-blue the whole firearm. He seemed to do a really good job on the rifle. That may be a place where you could...
I have one that I use my Silencerco Stainless Sparrow on and I think it is great. I am not an expert on suppressed weapons but it all seems to boil down to the ammunition used. With standard velocity ammunition, it seems to take away the muzzle blast at your ears but you still hear the crack...
Another vote for Mouthpiece. I live in North Louisiana and tried Mouthpiece based on everyone's recommendation. Very helpful and was able to get me set up with no problems.
interested in the firearm but due to # of posts I am not able to send any pm's. If you can send me a pm with contact info, I would like to set up a meet. Thanks.