No pics as of yet, but I will get some up when I can. Lathe has a 6" swing and 18" between centers. I Have used this to thread 16"barrels no problem.
Included is the basic lathe, on a wooden bench.
Atlas 4 jaw chuck,
import 3 jaw chuck,
faceplate,
dog,
two dead centers,
one live center,
wood turning centers,
keyless drill chuck,
two lantern tool posts,
four way tool holder,
left hand, right hand, center, and cut off tool holders,
steady rest,
complete set of change gears,
Parts manual,
chip tray,
knurling tool,
Boring bars and boring tool holder,
lots of tool bits.
Lathe works fine and can be seen under power.
Included is the basic lathe, on a wooden bench.
Atlas 4 jaw chuck,
import 3 jaw chuck,
faceplate,
dog,
two dead centers,
one live center,
wood turning centers,
keyless drill chuck,
two lantern tool posts,
four way tool holder,
left hand, right hand, center, and cut off tool holders,
steady rest,
complete set of change gears,
Parts manual,
chip tray,
knurling tool,
Boring bars and boring tool holder,
lots of tool bits.
Lathe works fine and can be seen under power.
Last edited:
