Cerakoting

[Garrett316]

I have an eotech vudu 1-10 and was wondering if it were possible to match it to the design/color of my rifle? If so where would be the best place to bring it?

 

[SwampyDog]

Yeah someone should be able to match it. I can't suggest where to go but I can tell where not to. Green Dragon Guns out of Denham. Guy is a an amateur despite doing it for years. He does not prep, disassemble, reassemble, or cure properly. He has damaged many firearms over the years and blames the owner. Avoid him like the plague

 

[scooterj]

Daniel does good work. Reach out to him. He’s in St.Amant

Plate-Tacular

Gun Coating, Gun Refinishing, Cerakote, Bath Bombs.

plate-tacular.com

 

[AdvancedLaser]

Do you want all the markings lasered back on after, or just kept a solid color and the markings blasted off ?

 

[Garrett316]

Didn’t think about that but I would like all the markings back on after.

My biggest concern is being able to do it to this scope since it does have rubber buttons that control the illuminated reticle.

 

[Garrett316]

This is the pattern of my rifle. Mine is just a little darker, more brown than fde.

 

[AdvancedLaser]

The rubber buttons will be fine. They wont bake them high enough to damage. The markings can be lasered back on.
That pattern looks more like rattle can than Cerakote. Or just an abstract Cerakote spray without stancils, and done by hand with something held against the receiver.

 

[Garrett316]

Daniel defense says it’s their “cerakote rattlecan”

 

[Dano’s Cerakote]

Matching someone else work is difficult without know exactly what color was used. The scope will be fine, curing temp is below 189degs

 

[Mitch Dufour]

Daniel defense says it’s their “cerakote rattlecan”

I was cringing for a moment at the thought of a DD being rattle canned.