bigjakewelch
Mill Spec
I decided to give the whole " I feel like cutting up a perfectly good Glock" thing a shot. It was pretty difficult to try and think of something that would push some limits, look good, function properly, and not look like everyone else's stuff. I was able to come up with a cut geometry that matched the grip angle and didn't compromise the slide integrity. A couple of opposing intersecting cuts on the front and leaving some slightly obtuse raised sections to grip. The rear serrations are to the matching angles and go from 0.001" in depth to 0.035" deep and are stepped in 0.100" increments. I was contemplating doing some lightning cuts/ports in the top and sides but may decide to only do some ball mill cuts to lighten it up for balance. I'll post more pics as it progresses.
Sent from my SAMSUNG-SM-G930A using Tapatalk
Sent from my SAMSUNG-SM-G930A using Tapatalk