Have the pins to figure out LS size and more knowledge than me to work on these?
I've got a FAL I built years ago, when they were cheap and got in over my head, either want to get it working or sell it for parts, can't remember if it's inch or metric (Imbel reciever).
Looking at it the extractor lines up nicely with the slot on the barrel so guess I got the barrel timing right? (I really don't remember much at all about building this one).
Also looks like the adjustment for the gas is screwed all the way out.
I do remember a test fire, tied gun to a tractor tire and a string to the trigger, that resulted it going bang but the round only came half way out, had to kick the bolt back since the case was stuck, and there was a long scratch on the right side of the case, no obvious bulging but couldn't finish extracting by hand. After that I tossed it in the back of the closet and forgot about it, until I went home for Thanksgiving this year.
I've got a FAL I built years ago, when they were cheap and got in over my head, either want to get it working or sell it for parts, can't remember if it's inch or metric (Imbel reciever).
Looking at it the extractor lines up nicely with the slot on the barrel so guess I got the barrel timing right? (I really don't remember much at all about building this one).
Also looks like the adjustment for the gas is screwed all the way out.
I do remember a test fire, tied gun to a tractor tire and a string to the trigger, that resulted it going bang but the round only came half way out, had to kick the bolt back since the case was stuck, and there was a long scratch on the right side of the case, no obvious bulging but couldn't finish extracting by hand. After that I tossed it in the back of the closet and forgot about it, until I went home for Thanksgiving this year.