whbonney26
Well-Known Member
I am looking for a company that does slide milling for a Dan Wesson 1911 in 10mm that I want to put a red dot on.
I originally was going to go with Docter USA because they do the milling and sell one of the smaller sights however; after reaching out to the over and over again and sending long emails to them and finally getting a very short reply I am not sure they are who I want to spend my money with.
Anyone have any ideas?
I originally was going to go with Docter USA because they do the milling and sell one of the smaller sights however; after reaching out to the over and over again and sending long emails to them and finally getting a very short reply I am not sure they are who I want to spend my money with.
Anyone have any ideas?
Last edited: