Using with pretty good success - three (3) - 8 minute runs with heat (unit gets up to 149 F)
Using 1/2 water, 1/2 vinegar, and few drops of Dawn dish washing soap.
Run in vibratory tumbler w/fine walnut hulls for 2 hours to finish
Questions:
Would distilled water be better than tap - my tap water is < 60 ppm hardness.
Would 100% vinegar be better (and still use Dawn)
Any 'tricks' to get the funk out of the primer pockets.
Is soaking in 91% alcohol or boiling brass before ultrasonic treatment helpful.
Does adding salt improve cleaning.
Thanks
Using 1/2 water, 1/2 vinegar, and few drops of Dawn dish washing soap.
Run in vibratory tumbler w/fine walnut hulls for 2 hours to finish
Questions:
Would distilled water be better than tap - my tap water is < 60 ppm hardness.
Would 100% vinegar be better (and still use Dawn)
Any 'tricks' to get the funk out of the primer pockets.
Is soaking in 91% alcohol or boiling brass before ultrasonic treatment helpful.
Does adding salt improve cleaning.
Thanks
Last edited: